Interlogix PIR - Page 8

8 PIR Camera Reference Manual
• Tamper alarms
• Faults: Device faults and technical alarms
• Custom type 1: User programmable type 1
• Custom type 2: User programmable type 2
See also “Camera event types” on page 3.
2.2.2.n.4.09.1.1 Burglar settings
1>Pic amount
1
Enter the BA settings menu to configure picture settings for burglar alarms.
2.2.2.n.4.09.1.1.1 Pic amount
1 Pic amount
>1<
Set the number of pictures taken after an event of the selected type occurs.
Allowed range is 1 to 30. The delay between pictures is set in “2.2.2.n.4.09.1.1.2
Frame rate” below.
2.2.2.n.4.09.1.1.2 Frame rate
2 Frame rate
>500 ms<
The menu defines a frequency of taking pictures on an event of the selected
type.
The menu is only available if “2.2.2.n.4.09.1.1.1 Pic amount” above value is
larger than 1.
The allowed values are 500 ms, 1 s, 5 s, 15 s, 60 s.
2.2.2.n.4.09.1.1.3 Pic quality
3 Pict quality
>QVGA<
The option defines resolutions of pictures taken upon an event of the selected
type. The following options are available:
• QVGA: 320 x 240 pixels
• VGA: 640 x 480 pixels
• QVGA and VGA: Two pictures at once, one in low resolution, and one in high.
2.2.2.n.4.09.1.2 Fire settings
2.2.2.n.4.09.1.3 Panic settings
2.2.2.n.4.09.1.4 Medical settings
2.2.2.n.4.09.1.5 Tamper settings