10 PIR Camera Reference Manual
3. Choose an input number.
4. Remove the PIR camera from mounting plate to activate it.
If an error occurs, the keypad shows an error message and beeps seven times.
Example:
The error can occur, for example, when you try to learn a device, which is
already programmed in the wireless expander. See “Camera unregistering”
below for details.
Next you are asked if you want to edit the new zone.
Chose Yes and press Enter to edit zone settings.
You are also asked to edit settings of the created camera.
If the device is programmed successfully, the keypad beeps twice.
Camera unregistering
Note: Once learned, the PIR camera cannot be learned on another wireless
expansion without prior unregistering from a previous expansion. To unregister
the PIR camera, revert it to the factory settings by following these steps:
1. Remove the PIR camera from mounting plate.
2. Insert factory setting jumper.
3. Remove batteries.
4. Wait 10 seconds.
5. Insert batteries.
6. Wait approximately 3 seconds until the PIR camera powers up.
7. Remove the factory setting jumper and mount the PIR camera.
After that, the PIR camera is defaulted and ready for learning in.
4.3 Cameras
17>Camera 17
18 Camera 18
The menu allows you to configure camera modules in wireless PIR cameras.
To Next Page
Loading...
