Interlogix TX-E101 User Manual (English)

To Next Page

Installation Sheet

Enrolling

Each keyfob is learned in to a control panel as an unsupervised sensor and uses one available zone slot. For

all Concord, Simon3 and Simon XT panels, use sensor group number 01, 03, 06 or 07. Please refer to your

specific control panel installation manual for full instructions.

Operation

Panic or Aux

If the keyfob is programmed using a panic or portable auxiliary group number, pressing the Lock and Unlock

buttons simultaneously will activate an audible or silent alarm (depending on group number) and initiate reports to

the central station.

Replacing the Battery

Because keyfobs are non-supervised devices, a low battery signal will only be received by the control panel when

the device is within range of the receiver and a button is pressed (if the device is not in use, no low battery signal

will be sent until a button is pressed). When the device is carried beyond the range of the receiver and/or is seldom

used/tested, the battery could wholly deplete without a warning of the battery condition being sent to the panel. If

the LED on the device appears dim or does not turn on when a button is pressed, it is a warning that the battery

may be low or depleted and should be replaced. To ensure proper functionality, test the device weekly and follow

these simple steps to replace the battery when necessary:

1. With a key or small screwdriver, press the black tab located at the bottom of the remote (fig.1) and slide the

chrome trim off.

2. Carefully separate the front and back piece of plastic to reveal the battery.

3. Replace with a CR2032 battery ensuring the + side of the battery faces up (fig.2).

4. Re-assemble the plastics and ensure they click together

5. Ensure the notch in the chrome trim is aligned with the back of the plastic. It will only go on one way (fig. 3).

Lock

Depending on your control panel:

Press once to arm in Stay mode.

Press twice to arm in Away mode.

Press three times to activate the latchkey feature.

Unlock

Press this button to disarm your system. You do

not have to enter your access code when you

use this key to disarm the system.

Light

For NetworX panels, press this button to arm the

system in Stay mode. For Concord, Simon 3 or XT it will

turn system controlled lights on or off.

Star

The star button function depends on the

individual panel programming. Refer to the

installation instructions for your panel.

Figure 1

Figure 2

Figure 3

TX-E101 Four Button Chrome Wireless Keyfob

Need help?

Do you have a question about the Interlogix TX-E101 and is the answer not in the manual?

Interlogix TX-E101 Specifications

General

Interface	RF Wireless
Input type	Press buttons
Product color	Black, Chrome
Buttons quantity	4
Housing material	Acrylonitrile butadiene styrene (ABS)
Backlight buttons	No
Brand compatibility	Interlogix
Customizable buttons	Yes
Remote control proper use	Security system
Certification	CE, FCC/IC
Maximum range	- m
Operating frequency	319.5 MHz
Number of devices supported	-
Operating temperature (T-T)	0 - 49 °C
Operating relative humidity (H-H)	5 - 95 %
Package type	Box
Quantity per pack	1 pc(s)
Battery type	CR2032
Battery voltage	3 V
Battery technology	Lithium