Intermatic, Inc. Spring Grove, IL 60061 www.intermatic.com 158HA11644
Thank you for purchasing Intermatic’s HomeSettings devices. With the HomeSettings program you
can reliably and remotely control lighting and appliances.
The outstanding features of the HomeSettings HA06 In-Wall Dimmer Switch include:
• Feedback that will allow you to see whether your device has received the ON/OFF/DIM signal.
• RF signal reliability – each HomeSettings product has a special feature that virtually
guarantees that RF signals are received
• Ease of installation
• Manual override
• Replaces standard indoor wall switches
• Use with décor style wall plate (not included)
• 2-way switching only
• Compatible with other Z-wave™ enabled devices
The HA06 In-Wall Dimmer is a Z-wave™ enabled device and is fully compatible with any Home
Settings network and any Z-wave™ enabled network. Z-wave™ enabled devices displaying the Z-
wave™ logo can also be used with Home Settings modules and controllers regardless of the
manufacturer, and Home Settings modules and controllers can also be used in other manufacturer’s
Z-wave™ enabled networks. Each module in a Home Settings network is designed to act as a
repeater. Repeaters will re-transmit the RF signal to ensure that the signal is received by its intended
destination by routing the signal around obstacles and radio dead spots.
INSTALLATION _
1. Turn off power to the wall switch circuit at the circuit breaker or remove the appropriate fuse in the
fuse box.
2. Install the HA06 In-Wall Dimmer according to Figure 2. Use the provided wire connectors to
connect the wires from the wallbox to the wires on the HA06. Note: A minimum load of 40
Watts is required for the proper operation of this switch.
3. Use the provided screws to mount the switch into the wallbox.
4. Attach décor style wall plate (not included).
5. Turn on power at the circuit breaker or replace the appropriate fuse in the fuse box.
6. Before operating the switch, check to make sure that the Air-Gap Switch (see figure 2) is slid to
the left, into the ON position. A vertical line (ON symbol “|”) can be seen next to the slide switch.
7. To manually turn ON the HA06 In-Wall Dimmer, press and release the top half of the wall switch
paddle. The green indicator LED will turn ON, and the attached light fixture will also turn ON.
8. To manually turn OFF the HA06 In-Wall Dimmer, simply press and release the bottom half of the
wall switch paddle. The green indicator will turn OFF and the attached light fixture will also turn
OFF.
9. To manually dim the HA06 In-Wall Dimmer, press and hold the Program/ON/OFF/DIM button
until the desired lighting level has been reached.
For Indoor Use Onl
MODEL HA06
IN-WALL DIMMER
To Next Page
Need help?
General