Intermatic RC613 - Timer Override Application - use Model RC615; Operation; DANGER! To Reduce the Risk of Injury:; To Set Code

OPERATION
B. Timer Override Application
- use Model RC615
An existing timer can only be upgraded if the
load connected to the timer is within the
capacity of the Receiver Module. Otherwise,
the timer mechanism must be replaced with
Intermatic Model PT1203M, see also other
choices on page 4.
1. Select the proper location (see Useful
Information on page 2) and install a radio
compatible timer on a vertical surface or
other support, using hardware, suitable for
the purpose.
2. Prepare the necessary conduit runs as required
by the installation layout and pull-in the
specified conductors.
3. Use one of the side knock-outs and a suitable
conduit-L, attach Model RC615 Receiver
Module to timer enclosure.
4. Follow wiring diagram B on the right,
make wire connections as shown.
5. Turn ON power, and test installation,
using the ON/OFF control of the timer.
6. Set code, see operating instructions on page 3.
A.
T
o Set Code
Receiver Modules have the capacity to “learn”
and remember a unique code, generated by a
tr
ansmitter
.
T
he tr
ansmitter will operate only the
designa
ted one or more receivers simultaneously.
In addition, each transmitter can “teach” and
operate up to three different sets of Receivers.
Also, more than one transmitter can be assigned
to oper
ate the same Receivers.
1. Turn ON the main power and manually operate the
load a few times, then turn load OFF.
2.
Holding the
Transmitter close to the Receiver
Module, press and hold the push button you
choose to operate that particular Module. The red
LED indicator should now be lit.
3. Press the “CODE SET” button on the face of the
Recei
v
er Module until the green light next to the
button flashes ONCE (about one second).
3
In case this device is used to operate pool/spa equipment...
DANGER! To Reduce the Risk of Injury:
... do not permit children to operate the Control Unit or use the Pool/Spa unless they are closely supervised at all times.
... test GROUND FAULT protection regularly. If it fails to reset, DO NOT USE THE POOL or SPA! Contact a qualified service technician.
4. Code setting is now complete. Release the
tr
ansmitter b
utton and test installa
tion b
y pr
essing
repeatedly on the chosen transmitter button.
The load should cycle ON/OFF, if not repeat
ste
ps 2 and 3 a
bo
ve.
5.
If mor
e than one Recei
v
er Module is in use, repeat
above procedure on the next Receiver Module and
hold down the SAME transmitter button in step 2
if the Module is supposed to function TOGETHER
with the f
ir
st or a DIFFERENT b
utton if it is
supposed to operate INDEPENDENTLY.
T
o er
ase all memorized codes,
pr
ess and hold
CODE SET button on Receiver Module, until the
g
r
een indica
tor light alongside goes out (in about 6
seconds).
To operate a Receiver Module with more than one
tr
ansmitter
,
set master code s
witc
h,
ne
xt to the
battery in transmitters to the same setting.