LowHalf full
Turn on the CK30.
Press I (the Power key) to turn on the CK30. When you
turn on the CK30, the screen turns on. If the screen does
not turn on, install a charged battery.
Check the battery level.
Turn on the backlight.
Change the contrast.
Change the beeper volume.
Press and release B (the Orange key),
and then press and release
E
to change the contrast.
Scan a bar code.
Point the CK30 at the bar code.
Press the Scan button or pull the trigger.
If your CK30 has a laser scanner, a red spot or narrow beam of light appears
near the bar code.
If your CK30 has an imager, a wide beam of light appears near the bar code.
Move the CK30 so the spot or beam is centered on the bar code.
When the Good Read light turns on, the bar code has been scanned.
1
2
3
Press I to turn off the
CK30.
Press down on the latch
and lift the battery out of
the CK30.
Insert the tabs on the
new battery into the
bottom of the opening.
Press the battery in
place to snap the latch.
Press and release C (the Green key), and then press
and release
E to change the beep volume.
1
2
3
If the battery is low, change it.
Press E (the Backlight key) to turn on the backlight.
The backlight makes the screen easier to see in dark
areas.
Depending on the kind of scanner your CK30 has, you may
need to move the CK30 closer to or farther from the bar code.
6001 36th Avenue West
Everett, WA 98203
U.S.A.
www.intermec.com
© 2003 Intermec Technologies Corp.
All Rights Reserved
CK30 Handheld Computer Operator’s Guide
*073407-001*
P/N 073407-001
Icons appear on
the screen when
the battery is
not fully charged.
I
I
4
To Next Page
Need help?
Capacity and Output Specifications
Weight and Dimensions
