Spacers are installed on the CN3 terminal holder to allow for optimum fit of the
holder on the 6822 portable printer.
To install the spacers
1 Center a spacer on each mounting post and press firmly to seat.
2 Align the terminal holder on the printer and insert the screws in the four
mounting holes.
3 Using a Phillips screwdriver, tighten the screws to 0.45 to 0.68 Nm (4 to 6 in-lb).
CN
3
Terminal Holder Spacer Installation
Instructions
Screw (4 places)
Spacer
(4 places)
To Next Page
