Printed in U.S.A. 440 04 6601 01 12/5/2014
SERVICE AND TECHNICAL SUPPORT
MANUAL
Single Stage, PSC Blower Motor
35” Tall, High Efficiency Condensing Gas Furnace
R9MSB0801716 (A Series Only)
R9MSB (All B Series)
Save this manual for future reference.
Safety Labeling and Signal Words
DANGER, WARNING, CAUTION, and NOTE
The signal words DANGER, WARNING,
CAUTION, and NOTE are used to identify levels of
hazard seriousness. The signal word DANGER is
only used on product labels to signify an immediate
hazard. The signal words WARNING, CAUTION,
and NOTE will be used on product labels and
throughout this manual and other manual that may
apply to the product.
DANGER − Immediate hazards which will result in
severe personal injury or death.
WARNING − Hazards or unsafe practices which
could result in severe personal injury or death.
CAUTION − Hazards or unsafe practices which
may result in minor personal injury or product or
property damage.
NOTE − Used to highlight suggestions which will
result in enhanced installation, reliability, or
operation.
!
WARNING
Signal Words in Manuals
The signal word CAUTION is used throughout
this manual in the following manner:
!
CAUTION
Signal Words on Product Labeling
Signal words are used in combination with
colors and/or pictures or product labels.
The signal word WARNING is used throughout
this manual in the following manner:
Safety−alert symbol
When you see this symbol on the unit and in
instructions or manuals, be alert to the
potential for personal injury.
TABLE OF CONTENTS
START−UP, ADJUSTMENT, AND SAFETY CHECK 3....
GENERAL 3........................................
PRIME CONDENSATE TRAP WITH WATER 3..........
PURGE GAS LINES 3...............................
ADJUSTMENTS 3..................................
CHECK INLET GAS PRESSURE 4....................
ADJUST MANIFOLD PRESSURE 5...................
ADJUST TEMPERATURE RISE 6.....................
ADJUST BLOWER OFF DELAY (HEAT MODE) 7.......
BLOWER OFF DELAY JUMPER POSITIONS 7.........
ADJUST COOLING AIRFLOW 7......................
ADJUST THERMOSTAT HEAT ANTICIPATOR 7........
CHECK SAFETY CONTROLS 7......................
CHECKLIST 7......................................
ALTITUDE DERATE MULTIPLIER FOR U.S.A. 8........
GAS RATE (CU FT./HR) 9............................
ORIFICE SIZE AND MANIFOLD PRESSURE 11.........
ORIFICE SIZE AND MANIFOLD PRESSURE 12.........
SERVICE AND MAINTENANCE PROCEDURES 13......
PRESSURE SWITCHES 13...........................
CLEANING HEAT EXCHANGERS 19...................
SEQUENCE OF OPERATION 23......................
PARTS REPLACEMENT INFORMATION GUIDE 27......
MODELS
R9MSB0601716B
R9MSB0801716A
R9MSB0801716B
R9MSB1002120B
R9MSB1202420B
Use of the AHRI Certified TM Mark indicates a
manufacturer’s participation in the program.
For verification of certification for individual
products, go to www.ahridirectory.org .
To Next Page
Need help?
General
