International Door Closers 44CI Series User Manual

LEFT HAND RIGHT HAND
INSIDE
OUT SIDE
INSIDE
OUT SIDE
RIGHT HAND
REVERSE BEVEL
LEFT HAND
REVERSE BEVEL
DOOR HANDING
US STANDARDIZATION PROCEDURE
C.W. = CLOCKWISE
C.C. W = COUNTER CLOCKWISE
PLEASE NOTE: TURNS REQUIRED ARE APPROXIMATE BECAUSE OF
VARIOUS DOOR CONDITIONS AND LOCATIONS. YOU MAY HAVE TO
FURTHER ADJUST SPRING TENSION TO SUIT YOUR REQUIREMENTS.
CONTROL RANGE
DOOR HANDS DETERMINED
FROM OUTSIDE
West: 800-544-4422 • East: 800-225-6737
www.intldoorclosers.com
COPYRIGHT 2023 INTERNATIONAL DOOR CLOSERS, INC
International Door Closers, Inc.
44CI Series
INSTALLATION
INSTRUCTIONS
Standard Mount
(Pull Side)
Right Hand Door - RH
Left Hand Reverse - LHR
Right Hand Door - RH
Left Hand Reverse - LHR
Top Jamb Mount
(Push Side)
Right Hand Door - RH
Left Hand Reverse - LHR
Parallel Mount
(Push Side)
DOOR
CLOSER
SIZE
MAXIMUM DOOR WIDTH
FULL TURNS OF POWER
ADJUSTMENT SCREW
EXTERIOR
(SWING OUT)
lNTERIOR 44CI
1 28”(0.71m) 32”(0.81m) 7 C.C.W
2 32”(0.81m) 36”(0.91m) 4 C.C.W
3 36”(0.91m) 42”(1.07m) 0(PRESET)
4 42”(1.07m) 48”(1.22m) 5 C.W
5 48”(1.22m) 54”(1.22m) 10 C.W
6 54”(1.37m) 58”(1.47m) 15 C.W
IT IS IMPORTANT TO CAREFULLY FOLLOW ALL INSTALLATION AND
MOUNTING INSTRUCTIONS WHEN INSTALLING ANY DOOR CLOSER.
CLOSING SPEED
CONTROL SCREW
C.C.W
SPRING POWER
ADJUSTMENT SCREW
BACKCHECK
SCREW
LATCHING SPEED
CONTROL SCREW
C.W.
(Page 1 of 4)
Back Check
Closing
Slow
Fast
Latching
Slow
Fast
Increase
Decrease
1
2
3

International Door Closers 44CI Series Specifications

General

Series	44CI
Fire Rating	Yes
Barrier Free	Yes
Adjustable Closing Speed	Yes
Adjustable Latching Speed	Yes
Backcheck	Yes
Delayed Action	Optional
Hold Open	Optional
Mounting	Parallel Arm, Regular Arm, Top Jamb
Arm Type	Regular Arm, Parallel Arm

Summary

General Installation Instructions

Mounting Type Diagrams

Visual guides for Standard, Top Jamb, and Parallel mount installations.

Door Handing Standardization

Procedure for determining door handing for installation purposes.

Control Range Overview

Diagram illustrating the adjustment range for closing and back check.

Standard Installation (Pull Side)

Regulation and Speed Adjustment

Instructions for adjusting closing and latch speeds.

Back Check Adjustment

Guidance on increasing back-check force.

Cover and Hold Open Features

Steps for cover installation and hold open adjustment.

Top Jamb Installation (Push Side)

Regulation and Speed Adjustment

Instructions for adjusting closing and latch speeds.

Back Check Adjustment

Guidance on increasing back-check force.

Cover and Hold Open Features

Steps for cover installation and hold open adjustment.

Parallel Arm Installation (Push Side)

Regulation and Speed Adjustment

Instructions for adjusting closing and latch speeds.

Back Check Adjustment

Guidance on increasing back-check force.

Cover and Hold Open Features

Steps for cover installation and hold open adjustment.