66
8. Set repeat function
This function is used to reach the blinds outside of the remote control range.
The wireless signal will be forwarded by the wireless receiver (shading).
1. Select the ‘Menu’ function
££©©
2.
press and hold = confirm selection
3.
press briefly = selection of display mode
©ªª©
= a)* No repeat function with
hardware RZINT01 (06/13)
©££©
= b) No repeat function
©§£ ©
= c) Repeat function only
for programmed element
©§§©
= d) Repeat function for all elements
©ªª©
4.
press and hold = confirm selection
©©©©
5. Further possibilities:
1)
press and hold = repeat process
2)
press briefly = to select an option from the ‘Menu’
3)
press and hold or no operation for 25 sec. =
finish installation mode
*Acquired shading until 06/13 = hardware RZINT01 (without repeater function).
When acquiring a new wireless sender after 07/13, please select point "3a" to ensure familiar operation.
Shading after 07/13 = hardware RZINT02 – functions as described above.
14_107_BHB_West.indd 66 02.06.14 13:00
To Next Page
Loading...