Jump Starter Pack Device Operation Instructions
ACR/QA 1829Nov
Section-B) Jump Starter Pack Device Use Continued:
Step #8) BEFORE ATTEMPTING TO START THE VEHICLE, confirm if the indicator light is illuminated.
If It is flashing, **REPEAT STEPS #5 & #6 ** By locating the Manual Activation Button; that is typically
on the side of the Smart Clamp Safety Box. (Once located press and hold the Manual Activation Button
for 1 to 3 seconds; and then release the Manual Activation Button. Confirm that the indicator light
should be solid and not flashing). This procedure may have to be repeated before each jump start
attempt.
Step #9) Once the vehicle has started and is running under its own power, safely disconnect the jump-starter
pack devices Smart Clamps red (+) positive battery terminal, and then disconnect the black (-) negative
ground battery clamp from the running vehicles battery port/post/or plug terminal.
To Previous Page
Loading...