EasyManua.ls Logo

Interstate PWR 7010 - Initiating Vehicle Start Attempt; Managing Failed Start Attempts and Recovery

Interstate PWR 7010
7 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Jump Starter Pack Device Operation Instructions
ACR/QA 1829Nov
Section-B) Jump Starter Pack Device Use Continued:
NOTE: (When Fully Charged), the jumper-starter pack device will provide up to
(20) Twenty repeated jump-start attempts.
Precaution: DUE TO BATTERY EXPLOSION AND CORROSIVE ACID INJURY
POTENTIAL, NEVER ATTEMPT TO BOOST OR JUMP START A
FROZEN BATTERY**
Precaution: BEFORE BOOSTING, MAKE CERTAIN TO CHECK FOR LOOSE OR
POOR FITTING POST AND TERMINAL CONNECTIONS. IT IS
RECOMMENDED THAT THE BATTERY POSTS & TERMINALS ARE
CLEAN, CORROSION-FREE AND TIGHTENED**
Step #6) Attempt to start the vehicle. If the vehicle starts & runs under its own power, proceed to Step #9
Step #7) If the vehicle does not start, or run under its own power and requiring an
additional jump start attempt; the following actions must be taken. To insure
proper jump starter pack device recovery; allow a (1) one minute time period
to pass before attempting to use the device for another vehicle jump start.