M6xM12
3
with the decorative ring
4
(For models without tables,skip to step 4)
shown.
shown.
5
Insert the fastening piece through the hole on the
tabletop. Hold the tabletop using your hand and
screw the fastening piece to the plastic connector
counter-clockwise,using the other hand. Tighten the
fastening piece.Screw the plastic nut to the plastic
connector counter-clockwise.Tighten the plastic nut.
Adjust the height of the tabletop.Loosen the plastic
nut and adjust the tabletop to the height you want.
Tighten the plastic nut.
6
To Next Page
Loading...