8571515 130 Watt Electric Hot Knife V4.0
LOW VOLTAGE
Low voltage may cause overheating due to higher power current being
drawn to the tool that will shorten the motor life.
An extension cord may cause a drop in power to the tool if it is too long
or the amperage rating is not correct. This may result in the following:
1. The tool will not activate when switched on.
2. The tool may switch on, but fails to maintain power when applied to
a workpiece.
3. The tool may overheat, possibly starting a fire.
Test the tool by plugging it directly to the power supply. If it powers on,
change the extension cord with the correct rating and as short as needed.
The workpiece may also need to be relocated closer to the power supply.
USE AND CARE OF THE TOOL
WARNING! Do not use the tool if the On /Off switch does not function
properly. Any tool that cannot be controlled with the ON / OFF switch is
dangerous and must be repaired.
1. Use the correct tool for the job. Maximize performance and safety by
using the tool for its intended task.
2. Do not modify this tool or use for a purpose for which it was
not designed.
3. This tool was designed for a specific function.
Do Not:
a. Modify or alter the tool, all parts and accessories are designed
with built-in safety features that may be compromised if altered.
b. Use the tool in a way for which it was not designed.
4. Avoid unintentional starts. Be sure the On /Off switch is in the
OFF position when not in use and before connecting it to any
power source.
8 For technical questions call 1-800-665-8685
To Next Page
Loading...