EN
IDENTIFICATION OF MAIN COMPONENTS / SYMBOLS 3
1) If you are using the machine every day in nor-
mal conditions, you can be exposed to a noise
level of 85 dB (A) or higher. Wear safetyglas-
ses and hearing protection.
2) Warning! Danger. Failure to use this machine
correctly can be hazardous for oneself and o-
thers.
3) Read the instruction manual before using the
machine.
4) Disconnect the plug from the mains before
commencing maintenance work or if the power
cord is damaged.
5) Do not leave the machine in the rain (or in damp
conditions).
2. SYMBOLS
[1]
Notice:
The vibration value indicated was determined with a standardized tool and can be used to make comparisons with other electric equipment
a
s well as temporary estimates of the load through the vibrations.
WARNING!
T
he vibration value may vary according to the usage of the machine and its fitted equipment, and be higher than the one indicated. Safety meas-
ures must be established to protect the user and must be based on the load estimate generated by the vibrations in real usage conditions. In
this regard, all the operational cycle phases must be taken into consideration, such as switching off or idle running.
M
aximum noise and vibration levels [1]
M
odel
SHT 500 - H 500 E SHT 600
Sound pressure level (EN 60745) dB(A) 84 86
– Measurement uncertainty dB(A) 3 3
G
uaranteed sound power level (2000/14/EC)
d
B(A)
9
8
9
8
Vibration level (EN 60745) m/s
2
2,85 2,99
– Measurement uncertainty m/s
2
1,5 1,5
TECHNICAL DATA Model
SHT 500 - H 500 E SHT 600
Power supply voltage V~ 230-240 230-240
Power supply frequency Hz 50 50
Engine Power W 500 600
Cutting lenght cm 45 55
Cutting movements min
-
1
1700 1700
Mass Kg 3,1 3,3
To Next Page
Loading...