To Next PageTo Next PageWhat to do if air is escaping after inflating Intex Sports & Outdoors?
Ensure the air passage is fully closed by turning the control dial to the center closed/pump off position. Also, make sure the manual inflation port cap is securely closed by firmly pushing the cap into the manual inflation port.
Why Intex 164412ND Sports & Outdoors air pump does not work?
First, ensure the pump is correctly plugged into a functioning power outlet. Then, turn the control dial fully clockwise to the inflation position. If the pump motor thermo-protector has activated, turn off and disconnect the power cord from the outlet, and let the pump rest for at least 30 minutes before attempting to use it again. If the issue persists, the internal air pump may be defective, remove it from the air bed and contact Intex service center for a replacement.
How to inflate or deflate Intex 164412ND air bed?
To inflate the air bed, turn the control dial fully clockwise until it stops. To deflate the air bed, turn the control dial fully counterclockwise until it stops.
General| Brand | Intex |
|---|---|
| Model | 164412ND |
| Category | Sports & Outdoors |
| Language | English |
Crucial safety guidelines and warnings before operating the air bed.
General operational guidelines for the air bed and pump.
Diagram and descriptions of all air pump and air bed components.
Step-by-step guide on how to inflate the air bed using the internal pump.
Step-by-step instructions for deflating the air bed.
Instructions for using an external pump via the manual inflation port.
Guidelines for properly folding and storing the air bed after use.
Procedures for detaching and replacing the air pump or other components.
Addresses common issues like air leaks, pump not working, and deflation problems.
Explains the terms, conditions, and coverage of the limited warranty for the air bed.
