(38IO) I638AA AIRBED ENGLISH 4.875” X 7.25” 07/28/2020
38IO
SAVE THESE INSTRUCTIONS
Page 2
OPERATING INSTRUCTIONS
General
• This airbed is ideal for temporary indoor and outdoor use particularly when no electrical
power outlet is readily available.
• This product operates on four (4) replaceable AA size batteries (not included).
• For maximum power use alkaline batteries. Remove batteries from equipment which is
not to be used for an extended period of time.
• Do not mix old and new batteries. Do not mix alkaline, standard (Carbon - Zinc), or
rechargeable (Nickel - Cadmium) batteries.
• Remove used batteries promptly.
• Keep away from heat or direct sunlight.
• Always purchase the correct size and grade of battery most suitable for the intended use.
• Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the device prior to battery installation.
• Ensure batteries are installed correctly with regard to polarity (+ and -).
• If leaking battery liquid (electrolyte) comes in contact with skin, wash immediately with
soap and water or neutralize it with vinegar or lemon juice. In case of contact with eyes,
rinse immediately with plenty of water for 10 minutes and seek medical advice.
• Make sure the area is flat, level, clean and free from sharp objects. To prevent puncture
or damage to the airbed, never drag the airbed across the ground. Lift the inflated airbed
when moving or changing location.
• During outdoor use, place a protective layer such as a tarp (not included) between the
selected surface and the airbed in order to prevent damage to the airbed.
•
No specific air pump maintenance is required.
•
For airbed cleaning use only clean cloth with mild soapy solution
.
Do not use any chemicals.
• In case of repairs, use only common PVC repair glue and patches. For flocked surfaces:
rub away the flocking material with an eraser first before applying the glue and/or patch.
•
To reduce the risk of electric shock or injury, do not expose to rain. Store indoors.
CAUTION
Proper inflation of the airbed.
The ambient temperatures of air have an effect on the airbed internal pressure. At low
ambient temperature the air will contract within the airbed and the airbed will feel softer:
add air as necessary. At high ambient temperature the air within the airbed will expand
significantly and the airbed will become hard and may burst: release air to avoid damage
to the airbed or to soften the feel. Do not expose the airbed to extreme temperatures (hot
or cold). Stretching is a natural characteristic of new vinyl. During initial use, the airbed
may become soft and require additional inflation to maintain desired firmness. This is
normal for the first few days of use. Dimensions shown are approximate and will vary due
to the vinyl temperature and the air temperature.
In no event shall Intex, their authorized agents or employees be liable for damages
(such as pin holes) to the airbed caused by negligence, ordinary wear and tear,
abuse and carelessness, or external forces.
IMPORTANT NOTE
To Next Page
Loading...
Need help?
General
