Intex SCL306 - General; Setup

(285PO) LED POOL SPRAYER ENGLISH SIZE: 4.875” X 7.25” 04/19/2020
English
285
PO
SAVE THESE INSTRUCTIONS
Page 2
General
• Notoolsarerequiredfortheassembly.
• FitsallroundandrectangularMetalFrameandUltraFramepools(notsuitableforEasy
 Set,OvalandPanelpools).
• Built-inhydroelectricgeneratorpowerstheLEDlight,nobatteriesorelectrical
 connectionrequired.
• Lightsin3colors:red,blueandgreen.Preset10secondsbetweencolorchange.
 Bestseenatnightorunderlowlightcondition.
• Pumpflowraterequired:3,785-12,112L/h(1,000-3,200gph).Systemflowrate 
 required:2,271-7,570L/h(600-2000gph).
• Makesurethepumpandthepoolaresetupandfilledwithwaterfirst.
• Removethesprayerbeforeplacingapoolcoveroverthepool.
• Whennotinuseremovefromthepoolandstoreinasafeplaceindoors.
• Forpoolandfilterpumpproblemsrefertotheirrespectiveowner’smanual.
Setup
1. Placethesprayerclampovertheselectedhorizontaltopbeamofthemetalframepool,
 withinreachofthefilterpumpreturnhose,andtightentheclampscrewsbyhand.
 Seefig1.
2. For filter pump with 38mm (1.5 in) hose and plunger valve:
a) Turnoffthefilterpump,closetheinletplungervalve,anddisconnectthepumpreturn
 hose(frompumptopool)fromtheinletplungervalve.
b) Attachthepumpreturnhosedirectlytothesprayerinlet.Seefig2.Turnonthefilter 
 pump.
FIG (1)
FIG (2)