To Next PageTo Next PageWhat to do if Intoximeters Alco-Sensor FST shows 'BAT' or won't power on?
If your Intoximeters Alco?Sensor FST® doesn't power on or displays 'BAT', it means the battery is low. Make sure the device is fully charged, or replace the batteries to resolve this issue.
What to do if Intoximeters Alco-Sensor FST Test Equipment says no sample provided?
If the Intoximeters Test Equipment indicates that no sample was provided within the 3-minute time interval, remind the subject to provide the sample within the required time frame.
What to do if Intoximeters Alco-Sensor FST Test Equipment shows insufficient power?
If your Intoximeters Test Equipment displays a message indicating insufficient power to conduct a subject test, ensure the device is properly charged, or replace the batteries.
What to do if Intoximeters Alco-Sensor FST Test Equipment detects Radio Frequency Interference (RFI)?
If the Intoximeters Test Equipment detects possible Radio Frequency Interference (RFI) and aborts the test, do not transmit on radios while conducting a test on the ASD.
What to do if Intoximeters Alco-Sensor FST result is higher than maximum reading?
If the result of the sample analysis with your Intoximeters Test Equipment is higher than the device's maximum reading, provide a lower concentration sample if possible.
What to do if Intoximeters Alco-Sensor FST indicates minimum breath flow requirements not met?
If the Intoximeters Test Equipment indicates that the subject has not met the minimum breath flow requirements after three attempts, instruct the subject to provide a proper breath sample.
Why does Intoximeters Test Equipment show VOID E29?
If your Intoximeters Test Equipment displays 'VOID' followed by 'E29', it means the amount of alcohol sampled is too high for the device to process. Ensure the subject does not have an excessive amount of alcohol in their system.
What to do if Intoximeters Alco-Sensor FST Test Equipment temperature is too hot?
If the Intoximeters Test Equipment displays that the device temperature is too hot for the test being performed, check the device temperature and ensure it is within the acceptable operating range.
What to do if Intoximeters Alco-Sensor FST Test Equipment temperature is too cold?
If the Intoximeters Test Equipment displays that the device temperature is too cold for the test being performed, check the device temperature and ensure it is within the acceptable operating range.
How to fix fuel cell base line issues in Intoximeters Alco-Sensor FST?
If the fuel cell base line does not meet requirements on your Intoximeters Test Equipment, conduct a proper accuracy check on the fuel cell.
General| Type | Breath Alcohol Tester |
|---|---|
| Sample Requirement | Breath sample |
| Display | LCD |
| Measurement Principle | Electrochemical Fuel Cell |
| Accuracy | ±0.005 % BAC at 0.100 % BAC |
| Operating Temperature | 32°F to 122°F (0°C to 50°C) |
| Power Supply | Rechargeable battery |
