38
C
R
O
S
S
B
R
A
C
E
S
MWD WHEELCHAIRS -
A. Reinstall the battery tray onto the wheelchair. Re-
fer to
INSTALLING/REMOVING BATTERY TRAY
in PROCEDURE 14 of this manual.
B. Reinstall the battery boxes onto the wheelchair.
INSTALLING/REMOVING BATTERY BOXES in
PROCEDURE 14 of this manual.
Locknut
(STEPS 4, 13)
Hex Bolt
(STEPS
4, 13)
Locknut
(STEPS 4, 13)
Pivot Link
Black Dust Cover
(STEPS 5, 15)
Wheelchair Frame
Hex Bolts
(STEPS 4, 13)
Washer
(STEPS 7, 12)
Crossbrace
Locknut
(STEPS
7, 12)
Hex Bolts
(STEPS 7, 12)
DETAIL "B" - FWD WHEELCHAIRS
ONLY
FIGURE 1 - ADJUSTING SEAT WIDTH - INTEGRATED SLING SEAT S
NOTE: Right and left is determined by sit-
ting in the wheelchair.
RIGHT LEFT
Front of
Wheelchair
Note orientation of hex bolt, washers, coved washers and locknut for installation of new crossbraces.
Front of Wheelchair
DETAIL "A" - (STEPS 8, 11)
MWD WHEELCHAIRS
FWD WHEELCHAIRS
Pivot Tube Plug Pin
(STEPS 9, 10)
Tie Wraps
(STEPS 6, 14)
19. If necessary, reinstall the shrouds. Refer to REMOV-
ING/INSTALLING SHROUDS in PROCEDURE 10
of
this manual.
PROCEDURE 11 CROSSBRACES
To Next Page
Loading...
