l The air lter is clogged.
l The device is tilted instead of being in an upright position.
l The oor surface is not at.
l This is normal. This unit is supplied with an Auto defrost feature.
l Check the correct installation of the drain hose.
l Check for any blockage or damage of the drain hose.
AS - Humidity module sensor error - Power o unit and temporarily unplug allowing
device to reset. If error persists, call for service.
ES - Tube Temperature sensor error - Power o unit and temporarily unplug allowing
device to reset. If error persists, call for service.
EC - Refrigerant leakage detection - Unit auto detects refrigerant leakage, if this occurs
the EC code will appear. Power o unit and temporarily unplug allowing device to reset.
If error persists, call for service.
P2 - The water tank is full or not installed correctly - Empty the tank or install it properly.
NOTE: All the pictures in the manual are for explanatory purposes only. The actual shape
of the unit you purchased may be slightly dierent, but the operations and functions are
the same.
To Next Page
Loading...
Need help?
General
