INVENTOR GLX06010 User Manual

30
Description
Possible
cause
Solution
Check if the water pressure
is high enough.
Straighten the water pipe.
Clean the inlet valve filter.
Check the drain hose for blockage.
Water injecting
problem during
wash cycle.
Overtime water draining
Restart the appliance. If problem
persists, please contact the
customer service.
Others
Water overflow
Restart the appliance.
Close the door properly and
restart.
Door is not closed properly
Trouble Shooting
Whenever there is a problem with the appliance, check if you can solve it following
the tables below. If the problem persists, please contact the customer service.
Description
Possible
cause
Solution
Close the door properly and
restart.
Check the laundry.
Door is not closed properly.
Clothes are stuck.
Safety protection
is activated.
Disconnect the power and
restart.
Water leakage
Connections are
not tight enough.
Check and fasten the water inlet
pipe.
Check and clean the outlet hose.
Clean and wipe the detergent
dispenser dry.
Abnormal noise
Check if the fixing bolts have
been removed
Make sure the appliance is
installed on a solid and level
floor.
Indicator or display
does not work
PC board or harness have
connection problems.
Switch off the power and check
if the mains plug is connected
properly.
Appliance does
not start
Detergent residues
in the detergent
dispenser
Detergent is damp
and/or clotted.
MAINTENANCE
Door can´t be
opened
Fixing bolts still in place.
Floor is not solid or level.
Error Codes
MAINTENANCE
Technical Specifications
Customer service
In case of questions please contact our customer service at:
Risk of electric shock
• Never try repair an appliance which is defective of presumed to be defective.
You may put your own and future users' lives in danger.Only authorised specialists are
allowed to carry out this repair work.
• Improper repair will void the warranty and subsequent damages can't be recognized!
Warning!
！！
Spare part for your appliance are available for a minimum of 10 years.
Transport
IMPORTANT STEPS WHEN MOVING THE APPLIANCE
•
• Check, if the door and the detergent dispenser are closed properly.
• Remove the water inlet pipe and the outlet hose from the house installations.
• Let the water drain completely from the appliance (see “Maintenance Cleaning the
drain pump filter”)
• Important: Re-install the 4 transport bolts in the back of the appliance.
• This appliance is heavy. Transport with care. Never hold any protruding part of the
machine when lifting. The machine door cannot be used as a handle.
Unplug the appliance and close the water inlet tap.

INVENTOR GLX06010 Specifications

General

Brand	INVENTOR
Model	GLX06010
Category	Washer
Language	English