inventum GF552HL - User Manual

Questions and Answers

M
michaeldominguezAug 14, 2025
Why is my inventum GF552HL Fryer not working?
- M
  Mary SantiagoAug 14, 2025
  Your Inventum Fryer might not be working due to several reasons: * The appliance is not plugged in. In this case, plug the appliance in an earthed wall socket. * The timer is not set. Turn the timer knob to the required preparation time to activate the appliance. * The pan is not placed correctly. Slide the pan correctly in the appliance. * The overheating protection is turned on. Unplug the appliance, leave it to cool down and contact a service point of Inventum or your supplier.
D
Derrick RoblesAug 17, 2025
What to do if white smoke is coming out of my inventum GF552HL Fryer?
- L
  Lisa BakerAug 17, 2025
  If you notice white smoke coming from your Inventum Fryer, it's likely due to frying greasy ingredients, which causes oil to leak into the pan. This oil produces white smoke, and the pan may heat up more than usual. This does not affect the appliance or the end result. Another cause might be grease residues from previous use. Make sure you clean the pan properly after each use to prevent this.
L
Lori MurphyAug 20, 2025
What to do if the pan will not slide properly into the inventum GF552HL Fryer?
- J
  Joseph CunninghamAug 21, 2025
  If the pan of your Inventum Fryer doesn't slide in properly, it could be because there are too many ingredients in the basket. Avoid filling the basket completely. Also, make sure the basket is correctly placed in the pan; push it in until you hear a click.
W
whitneystricklandAug 25, 2025
Why are my ingredients not done in the Inventum Fryer?
- J
  Jonathan EstradaAug 25, 2025
  If your ingredients aren't fully cooked in the Inventum Fryer, it might be because you're putting too much food in the basket at once. Try cooking smaller batches for more even frying. Also, check that the temperature and preparation time are set correctly.
J
Jessica RubioAug 27, 2025
Why are my fresh fries fried unevenly in the Inventum Fryer?
- L
  Lori PerkinsAug 27, 2025
  Unevenly fried fresh fries in your Inventum Fryer can result from using the wrong type of potato. Use fresh potatoes that stay firm during frying. Also, ensure you rinse the potato sticks properly to remove starch from the outside.
N
Nathan FordAug 31, 2025
Why are my fried snacks not crispy in the inventum GF552HL Fryer?
- H
  Hector DanielAug 31, 2025
  If your fried snacks aren't crispy when they come out of the Inventum Fryer, it could be that they are meant to be fried in a traditional deep fat fryer. Try using oven snacks or lightly brush some oil onto the snacks for a crispier result.
S
smithsherrySep 3, 2025
Why are the ingredients fried unevenly in the inventum GF552HL?
- A
  alexwileySep 3, 2025
  If the ingredients are fried unevenly in your Inventum Fryer, it may be because certain types of ingredients need to be shaken halfway through the preparation time. Ingredients that lie on top of or across each other (e.g. fries) need to be shaken halfway through the preparation time.
N
nnguyenSep 6, 2025
Why are my fresh fries not crispy when they come out of the inventum GF552HL Fryer?
- D
  David HarmonSep 6, 2025
  The crispiness of fresh fries from the Inventum Fryer depends on the oil and water content. Ensure the potato sticks are dried properly before adding oil. You can also cut the potato sticks smaller or add a bit more oil for a crispier result.
C
Christopher GonzalezSep 10, 2025
What to do if inventum GF552HL Fryer stops working half way through?
- M
  Mr. Jonathan PhamSep 10, 2025
  If your Inventum Fryer stops working halfway through, it's possible the timer hasn't been turned far enough. Turn the timer past at least 15 minutes and then turn it back to the desired number of minutes.