inventum IKI6021 - Problems and Solutions

problems & solutions
8
If there is an error, an error code will be shown at the displays.
Error code Cause Solution
E1 Cooling fan is disabled. Contact the service department of Inventum.
E3 Supply voltage is too high.
Have the installation checked by a qualified
electricien.
E4
Supply frequency is different from
the rated values (50Hz).
Have the installation checked by a qualified
electricien.
E5 The hob is overheated.
Switch the appliance off and let the cooking zones
cool down.
E6 Control defect. Contact the service department of Inventum.
E7 Coil temperature sensor is defect. Contact the service department of Inventum.
E8
Cooler temperature sensor is
defect.
Contact the service department of Inventum.
E9 Calibration error. Contact the service department of Inventum.
34 • English