cleaning & maintenance
7
6mm
51 mm
Always unplug the appliance from the supply if it is left
unattended and before assembling, disassembling and during
cleaning.
Disassemble the motor part from the accessory.
• Wipe the motor part and the connector with a damp cloth.
• Rinse the lid of the chopper and the blender shaft with water.
• Do not use any abrasive or strong detergents. These can
damage the housing.
• Never place the motor part, the power cable or the plug
in water or any other liquid.
• These accessories may be washed by hand:
- blender shaft
- measuring cup with anti-slip base/lid
- whisk
- chopper with anti-slip base/lid
- knife
Be careful when cleaning the accessories by hand.
The knives of the blender shaft and the chopper are
extremely sharp.
mounting
8
The stick mixer is supllied with a wall bracket.
• Drill two holes in the wall according to the measurements on
the picture.
• Push the two enclosed plugs in the holes.
• Mount the wall bracket with the enclosed screws.
• Place the stick mixer on the wall bracket.
English • 13
To Next Page
Loading...
