Inverter Fusion PLASMA CUT 40 User Manual (English)

Questions and Answers:

N
Natalie KingJul 31, 2025
Why are sparks shooting upward when using Inverter Fusion PLASMA CUT 40 Welding System?
- C
  candicemooreJul 31, 2025
  If the sparks are shooting upward instead of down through the material when using your Inverter Fusion Welding System, it could be due to several reasons: * The plasma torch might not be piercing the material, in which case you should increase the current. * The torch may be too far away from the stock, so decrease the distance. * The material may not be grounded properly, so check connections for a proper ground. * The travel speed may be too fast, so reduce the speed.
G
Gary ThompsonAug 5, 2025
What to do if the arc stops while cutting with Inverter Fusion PLASMA CUT 40 Welding System?
- C
  christopher16Aug 5, 2025
  If the arc stops while cutting with your Inverter Fusion Welding System, it could be due to: * Cutting speed being too slow, so try increasing the speed. * The torch being too high, away from the material, so lower the torch to the recommended height. * Worn torch parts, so inspect and repair or replace them. * The workpiece ground cable being disconnected, so connect the Workpiece Ground Clamp to the workpiece or steel table.
H
Heather ChaseAug 10, 2025
How to prevent dross build-up on cuts with Inverter Fusion PLASMA CUT 40 Welding System?
- T
  Thomas ChanAug 11, 2025
  Dross build-up on parts of cuts when using your Inverter Fusion Welding System can occur if: * The tool or material is building up heat, so allow the material to cool before continuing. * The cutting speed is too slow or the current is too high, so increase the speed and/or reduce the current until dross is minimized. * The torch parts are worn, so inspect and repair or replace them.
M
Mrs. Kimberly BookerAug 15, 2025
Why is there insufficient penetration with Inverter Fusion PLASMA CUT 40?
- M
  Michaela CarlsonAug 15, 2025
  If you're experiencing insufficient penetration with your Inverter Fusion Welding System, consider the following: * Your cutting speed might be too fast, so slow down the travel speed. * The torch might be tilted too much, so adjust the tilt. * The metal might be too thick, so several passes may be necessary. * The torch parts might be worn, so inspect and repair or replace them.
M
michaelcruzAug 20, 2025
What to do if the torch won't come on for Inverter Fusion Welding System?
- J
  Justin WillisAug 20, 2025
  If the torch will not come on for your Inverter Fusion Welding System, check the following: * Ensure the power switch is in the On position. * Verify the air supply is not compromised. * Make sure the workpiece Ground Clamp is attached to the workpiece or to a steel table with the workpiece securely clamped to the table.