What to do if Inverter 3007 shuts off during operation?
If your Inverter Heater shuts off during ignition or operation, clear any water or dust from the fuel filter and fixed tank, then restart it. If the problem persists, it is recommended to refer to your dealer.
What to do if power failure or overheat prevention device is activated in Inverter 3007 Heater?
If the power failure or overheat prevention device is activated on your Inverter Heater, first, remove any obstructions from the front of the unit. Then, after the unit has cooled down, inspect and clean the warm air intake before restarting the unit.
Why does smoke and smell come from Inverter 3007 Heater when switched off?
If you notice smoke and smell coming from your Inverter Heater when it is switched off, it's likely due to heat-resistant paints and dust burning off. To resolve this, ventilate the room until the smoke and smell disappear.
How to fix Inverter 3007 Heater that does not ignite after long time?
If your Inverter Heater doesn't ignite at the start of the season or after a period of disuse, wait 4 to 5 minutes to allow fuel to fill the fixed tank before attempting ignition. This issue may be due to air in the fuel system. Try the ignition procedure 2 or 3 times.
What to do if auto shut-off device activated in Inverter 3007?
If the auto shut-off device on your Inverter Heater is activated, check around the unit and then restart it.
Why Inverter Heater does not ignite immediately?
If your Inverter Heater does not ignite immediately, allow approximately 90 to 120 seconds for preheating, which is necessary for fuel volatilization. The preheating time will vary depending on the ambient temperature.
Why white smoke comes from Inverter Heater?
When igniting or extinguishing your Inverter Heater, some white smoke and/or smell is normal.
Why flames of Inverter 3007 Heater turn brilliant reddish orange?
If the flames of your Inverter Heater turn a brilliant reddish-orange and there is a sound like running water while the unit is burning, this is normal under certain conditions. This can occur if the unit is burning in salty air (such as near the sea), in a humid environment, or in an atmosphere containing impurities, or if the unit is used with an ultrasonic humidifier. This also happens when fuel flows from the removable tank to the fixed tank.
Why Inverter 3007 Heater makes a slight noise on ignition?
If your Inverter Heater makes a slight noise upon ignition and when switched off, this is a normal occurrence. The unit expands when heated and contracts when switched off, which causes this noise.
Why is there a clack sound in Inverter Heater while burning?
If you hear a clack sound in your Inverter Heater while it's burning, this is the normal sound of the magnetic pump.
To Next Page
General