WARNING Read all safety warnings and instructions. Failure to follow
all the warnings and instructions may result in electric shock, re and/
or serious injury.
SAVE ALL THE WARNINGS AND INSTRUCTIONS FOR FUTURE
REFERENCE.
WORK AREA SAFETY
a) Keep work area clean and well lit. Cluttered and dark areas invite
accidents.
b) Do not operate power tools in explosive atmospheres, such as in
the presence of ammable liquids, gases or dust. Power tools create
sparks which may ignite the dust or fumes.
c) Keep children and bystanders away while operating a power tool.
Distractions can cause you to lose control.
ELECTRICAL SAFETY
a) Power tool plugs must match the outlet. Never modify the plug in
any way. Do not use any adapter plugs with earthed (grounded)
power tools. Unmodied plugs and matching outlets will reduce risk
of electric shock.
b) Avoid body contact with earthed or grounded surfaces such as
pipes, radiators, ranges and refrigerators. There is an increased risk
of electric shock if your body is earthed or grounded.
c) Do not expose power tools to rain or wet conditions. Water entering
a power tool will increase the risk of electric shock.
d) Do not abuse the cord. Never use the cord for carrying, pulling or
unplugging the power tool. Keep cord away from heat, oil, sharp
edges or moving parts. Damaged or entangled cords increase the
risk of electric shock.
e) When operating a power tool outdoors, use an extension cord
suitable for outdoor use. Use of a cord suitable for outdoor use
reduces the risk of electric shock.
f) If operating a power tool in a damp location is unavoidable, use
a residual current device (RCD) protected supply. Use of an RCD
reduces the risk of electric shock.
PERSONAL SAFETY
a) Stay alert, watch what you are doing and use common sense when
operating a power tool. Do not use a power tool while you are tired
or under the inuence of drugs, alcohol or medication. A moment
of inattention while operating power tools may result in serious
personal injury.
b) Use personal protective equipment. Always wear eye protection.
Protective equipment such as dust mask, non-skid safety shoes,
hard hat, or hearing protection used for appropriate conditions will
reduce personal injuries.
c) Prevent unintentional starting. Ensure the switch is in the o position
before connecting to power source and /or battery pack, picking
up or carrying the tool. Carrying power tools with your nger on
the switch or energising power tools that have the switch on invites
accidents.
d) Remove any adjusting key or wrench before turning the power tool
on. A wrench or a key left attached to a rotating part of the power
tool may result in personal injury.
e) Do not overreach. Keep proper footing and balance at all times. This
enables better control of the power tool in unexpected situations.
f) Dress properly. Do not wear loose clothing or jewellery. Keep your
hair, clothing and gloves away from moving parts. Loose clothes,
jewellery or long hair can be caught in moving parts.
POWER TOOL USE AND CARE
a) Do not force the power tool. Use the correct power for your
application. The correct power tool will do the job better and safer at
the rate for which it was designed.
b) Do not use the power tool if the switch does not turn it on and
o. Any power tool that cannot be controlled with the switch is
dangerous and must be repaired.
c) Disconnect the plug from the power source and/or the battery pack
from the power tool before marking any adjustments, changing
accessories, or storing power tools. Such preventive safety
measures reduce the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of children and do not allow
persons unfamiliar with the power tool or these instructions to
operate the power tool. Power tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check for misalignment or binding of moving
parts, breakage of parts and any other condition that may aect the
power tools operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly maintained power
tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting
tools with sharp cutting edges are less likely to bind and are easier
to control.
g) Use the power tool, accessories and tool bits etc. in accordance
with these instructions, taking into account the working conditions
and the work to be performed. Use of the power tool for operations
dierent from intended could result in a hazardous situation.
SERVICE
a) Have your power tool serviced by qualied repair person using only
identical replacement parts. This will ensure that the safety of the
power tool is maintained.
EXTRA SAFETY REGULATIONS CONCERNING HEDGE TRIMMER
• Hold the power tool by insulated gripping surfaces only, because
the cutter blade may contact hidden wiring or its own cord. Cutter
blades contacting a “live” wire may make exposed metal parts of
the power tool “live” and could give the operator an electric shock.
• Keep all parts of the body away from the cutter blade. Do not
remove cut material or hold material to be cut when blades are
moving. Make sure the switch is o when clearing jammed material.
A moment of inattention while operation the hedge trimmer may
result in serious personal injury.
• Carry the hedge trimmer by the handle with the cutter blade
stopped. When transporting or storing the hedge trimmer always t
the cutting device cover. Proper handling of the hedge trimmer will
reduce possible injury form the cutter blades.
• Keep cable away from cutting area. During operation the cable may
be hidden in shrubs and can be accidentally cut by the handle.
HEDGE TRIMMER
WARNING -To reduce the risk of injury, user must read instruction
manual. Save all warnings and instructions for future reference.
Intended Use and Reasonable Foreseeable Misuse:
The hedge trimmer should only be used for trimming hedges, bushes
and shrubs. Other use of the trimmer, not included in this manual,
could damage the trimmer or seriously injure the operator and is
therefore expressively excluded from the application range.
FEATURES
Item Description
1 Trimmer Blade
2 Handle Guard
3 Front Handle Switch
4 On/O Switch
5 Cable Hook
User Manual
Electric hedge trimmer
Green Series
To Next Page
Need help?
General