Why does my IOGear UPS beep every second and show a warning code?
This usually means the IOGear UPS is overloaded. Try removing some devices connected to the UPS. If the devices are being fed directly by the electrical network via Bypass, remove excess loads, shut down the UPS, and then restart it.
What to do if my IOGear UPS shows fault code 43 and icon on the LCD display?
The IOGear UPS likely shut down automatically due to an overload at the output. Remove some of the connected devices to decrease the load, and then restart the UPS.
What to do if my IOGear UPS battery backup time is shorter than expected?
The batteries may not be fully charged or they might be defective. First, charge the batteries for at least 5 hours and then check their capacity. If the issue continues, it is recommended to contact your dealer to replace the battery.
Why does my IOGear UPS show fault code 49 on the LCD display?
The IOGear UPS is experiencing over input current. You should remove some of the connected devices to reduce the load on the UPS output.
What does it mean if my IOGear UPS is flashing an icon and warning code with beeping?
This can happen if the EPO function is activated, if the line and neutral conductors of the UPS input are reversed, or if the external or internal battery is incorrectly connected. To resolve this: 1. Set the circuit in a closed position to disable the EPO function. 2. Rotate the mains power socket by 180 degrees and then connect it to the UPS system. 3. Check that all batteries are well connected.
What to do if my IOGear UPS shows fault code 2A on the LCD display?
The most likely cause is a short circuit on the charger output. Check the battery wiring of the connected external pack to ensure it is not short circuiting.
How to fix IOGear UPS when there is no indication and no alarm?
First, check that the input power cord is firmly connected to the mains. Also, make sure the AC input power cord is correctly connected to the AC input, and not the UPS output.
To Next Page
General