To Next Page

To Previous Page

Tape Head Cleaning

For continued high performance from Retro Rocker, periodically clean the head, pinch roller, and

capstan every 10-20 hours of operation.

To clean the tape deck:

1. Power off Retro Rocker.

2. Press the Stop/Eject button to open the cassette holder.

3. Remove any tape in the deck.

4. Moisten a new cotton swab with isopropyl alcohol (70-80%).

5. Carefully rub the face of each head, pinch roller, and capstan with the moistened cotton swab.

6. Let the cassette holder dry for 5-10 minutes before putting a tape back in it.

Pairing a Bluetooth Device

1. Adjust the Function switch on Retro Rocker to the BT/USB/SD position.

Note: If an SD card and/or a USB flash drive is inserted, remove these in order to pair to a

Bluetooth device.

2. Turn on your Bluetooth device.

3. Navigate to your Bluetooth device’s setup screen, find Retro Rocker and connect. A voice

prompt will be heard saying “Bluetooth pairing” when pairing and “Bluetooth connected” when

connected to your Bluetooth device.

Note: If your Bluetooth device prompts for a pairing code, enter “0000”.

4. Press and hold the Play/Pause button to disconnect from a paired Bluetooth device. A voice

prompt will be heard saying “Bluetooth disconnected” when disconnected from the Bluetooth

device.

Questions and Answers:

Need help?

Do you have a question about the ION Retro Rocker and is the answer not in the manual?

ION Retro Rocker Specifications

General