31
EN
INFORMATION REGARDING THE EQUIPMENT’S APPLICATION:
Source of water to be treated
PUBLIC WATER SUPPLY NETWORK
OTHER
* Pre-treatment of the system:
* Input hardness of the system (ºF):
* Equipment entry TDS (ppm):
* TDS of water produced (ppm):
* Input pressure of the system (bar):
CONTROL DE LOS PASOS DE LA INSTALACIÓN:
Assembly of pre-filter: Installation of isolation by-pass:
Installation of overflow drain: Proper installation of drain:
Start-up according to the protocol: Verification of brine suction / tank filling:
Checking of connectors: Pressurized system water tightness check:
Inlet hardness measuring: Programming of the system:
Outlet hardness measuring: Adjustment of residual hardness:
COMMENTS
* Installation and initial operation results:
CORRECT (equipment installed and working properly. Produced water is suitable for this application).
OTHER:
TECHNICIAN IDENTIFICATION: CONFORMITY OF EQUIPMENT OWNER:
*Ref. Maintenance contract:
The maintenance contract IS ACCEPTED
The maintenance contract is NOT ACCEPTED
Model/Ref.:
Owner:
Street:
Telephone:
Town/City:
State/County: Postcode:
12. INSTALLATION REGISTRATION SHEET
NOTES FOR TECHNICIAN/INSTALLER: Please read this manual carefully. In the event of any queries please contact your
distributor’s Technical Assistance Service (S.A.T.). The information marked with (*) must be filled in and copied by the
technician from the WARRANTY SHEET. The technician must keep this sheet and provide it to the distributor if required
to do so, in order to improve the after-sales service and the customer service. The technician who carries out the
installation and initial operation should be suitably qualified.
COMPANY AND/OR INSTALLER, DATE AND SIGNATURE:
I have been clearly informed regarding the correct use and main-
tenance required for the installed equipment, and have been
offered a maintenance contract as well as being informed of how
to contact the Customer Service Department in the event of wi-
shing to make any information requests, to report an equipment
breakdown or malfunction, or to request any technical services.
GUARANTEE OF THE SYSTEM FOR THE DISTRIBUTOR:
The distributor shall only be held responsible for the replace-
ment of parts showing a lack of conformity. The repair of the
system and the costs that may arise (labour, transport costs,
travelling expenses, etc.) will be assumed by the distributor
according to that agreed in the general conditions of sales and
contracting, hence the distributor will not have the right to claim
these costs to the manufacturer.
Comments:
SERIAL NUMBER:
To Next Page
Loading...