EasyManua.ls Logo

ionmax Ray Ion801 - Safety Instructions

ionmax Ray Ion801
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SAFETY INSTRUCTIONS
PLEASE READ ALL THE INSTRUCTIONS CAREFULLY BEFORE
USING THE FAR INFRARED HEATER AND SAVE THEM FOR FUTURE
REFERENCE.
This appliance is intended for domestic and light commercial use only. Any other use is not
UHFRPPHQGHGDQGPD\FDXVH¿UHHOHFWULFDOVKRFNVRURWKHULQMXU\WRSHUVRQVRUSURSHUW\
Ɣ Use only as directed in the User Manual.
Ɣ Do not allow children or persons with reduced physical, sensory, or mental capabilities to
operate the unit without adult supervision.
Ɣ Only designed for use in a 200-240V, 50Hz outlet.
Ɣ The heater must not be located immediately below a socket outlet.
Ɣ Do not use this heater with a programmer, timer, separate remote-control system or any
RWKHUGHYLFHWKDWVZLWFKHVWKHKHDWHURQDXWRPDWLFDOO\DVD¿UHULVNH[LVWVLIWKHKHDWHULV
covered or positioned incorrectly.
Ɣ Do not use this heater in the immediate surroundings of a bath, a shower or a swimming
pool, or in any situation where it could get wet.
Ɣ .HHSDOOÀDPPDEOHPDWHULDOVVXFKDVIXUQLWXUHEHGGLQJSDSHUFORWKLQJDQGFXUWDLQVDW
least 90 cm from the front and top of the appliance. Do not use the appliance in areas
ZKHUHJDVROLQHRURWKHUÀDPPDEOHOLTXLGVDUHXVHGRUVWRUHG
Ɣ This appliance gets very hot when in use. To prevent burns, do not touch hot surfaces with
bare skin. Use the handle when moving the appliance. To prevent overheating and the risk
RI¿UH'2127FRYHUWKHDSSOLDQFHZKLOHLWLVLQRSHUDWLRQ
Ɣ Connect the appliance directly to a suitable outlet. DO NOT use this appliance with an
extension cord or outlet strip. To prevent current overload and blown fuses, make sure
that no other appliance is plugged into the same outlet or into another outlet wired into the
same circuit.
Ɣ It is normal for the heater’s plug and cord to feel warm to the touch. However, an
excessively hot or deformed plug or cord is not normal and may be the result of a
defective electrical outlet. Defective outlets must be replaced before using the heater.
Plugging the heater into a worn outlet may result in overheating of the power cord or may
EHD¿UHULVN
Ɣ If the supply cord is damaged, to reduce the risk of malfunction it must be replaced by the
PDQXIDFWXUHULWVVHUYLFHDJHQWRUDOLFHQVHGDQGTXDOL¿HGSURIHVVLRQDO
Ɣ Make sure that the plug is fully inserted into the outlet. Wall outlets may deteriorate with
time, so check the plug periodically for signs of overheating or deformation. If the outlet
has deteriorated, stop using it and have it repaired.
Ɣ To protect against electrical shocks, do not immerse the unit, plug or cord in water, or
VSUD\ZLWKOLTXLGV
Ɣ 7RSUHYHQWGDPDJHWRWKHXQLWVZLWFKWKHKHDWHURII¿UVWE\SUHVVLQJWKH67$1'%<NH\
before unplugging the power cord.
Ɣ Do not run the power cord under carpeting, or cover it with rugs or runners. Arrange the
cord away from areas where it may be tripped over.
Ɣ 7RUHSDLUWKHXQLWWDNHLWWRDTXDOL¿HGVHUYLFHHQJLQHHU5HSDLUVFDUULHGRXWE\XQTXDOL¿HG
people may cause damage to the unit or injury to persons or property and void the
warranty.
1