AZ Mount Pro Binocular Adapter Assembly
Tool Needed: A set of metric Allen wrench
Parts Included:
1. Tighten locking knob
2. Remove hand controller hanger
3. Set the mount at Zero Position. The arrow mark on
dovetail saddle should point upward. Remove
dovetail saddle from the mount by releasing 4
screws.
4. Release 4 screws on saddle adapter. remove the
adapter and rotate it 90 degree. Re-install the
screws and tighten them.
You have to rotate the saddle adapter itself, not by
releasing the locking knob to rotate it wth the mount
ALT axle.
5. Install bino dovetail saddle onto the long bino
adapter plate.
To Next Page
