iOptron iPolar CEM120

To Next Page

iPolarInstallation–CEM120Internal(#3339A‐120)



1. Remove two screws that hold the Cable

Management System (CMS) panel using a

2.5mm hex wrench.



2. Pull the panel open. The CMS_D board

should look like the following.

If your CMS_D has an USB plug for the

iPolar, please contact iOptron for a modified

one.

3. Unthread CEM120 polar scope front cover.

4. Remove counterweight shaft house by

unscrewing three screws (one socket screw

on top and two set screws on the side).

Need help?

Do you have a question about the iOptron iPolar CEM120 and is the answer not in the manual?

iOptron iPolar CEM120 Specifications

General