1
The Fuse Saver
®
can be used in place of a mini
or standard fuse using the dual fuse adapter.
Mini Fuse Standard Fuse
WARNING
RISK OF ENTANGLEMENT
RISK OF FIRE
RISK OF BURN
RISK OF EXPLOSION
WEAR SAFETY GOGGLES
10 Amp-Red
#8005-10AMP
15 Amp-Blue
#8005-15AMP
20 Amp-Yellow
#8005-20AMP
10 ft. cable with dual
ATC Standard and Mini
Fuse Box Adapter
#8005-5
WHAT’S INCLUDED
WARNINGS
• To prevent arcing and avoid unnecessary wear that voids your warranty, always disconnect
battery before inserting the tool.
• If any arcing is found during installation or use, disconnect immediately and recheck system.
• Do not connect to areas that have been subjected to heat from loose fuse contact (i.e. melted
plastic housing in area of fuse for the circuit to be tested).
• Do not connect to loose or corroded contacts. This can cause arcing, extreme heat, or fire.
• Do not assume that the fuse removed is the proper rated amperage for that circuit. Check
vehicle’s owner manual for proper fuse size.
• Do not store or use in temperatures exceeding 110°F or below 40°F.
THIS TOOL IS NOT TO BE STORED OR OPERATED IN WET CONDITIONS.
INTRODUCTION
The Fuse Saver
®
provides a fast and safe solution for troubleshooting short circuits without
blowing fuses or damaging vehicle electrical systems. The kit includes resetting, thermal breaker
handles which are color coded to match the vehicle fuses. Simply plug the Fuse Saver
®
directly
into the fuse box in place of the troubled circuit’s fuse via the supplied 10 ft. dual type fuse box
cable adapter. When a short is present, the breaker will pop. The user must then manually reset
the breaker to reapply power to the circuit.
To Next Page
Loading...