IPC Hot Line-H - Pag. Use

English
- 22 -
or the plug is unplugged from
the socket.
- When the water cleaner is not
used, close the safety device
onthehandle.(g.10).
- Dry use of the water cleaner
causes serious damage to
pump gaskets.
canbettedwithaheadwithrotarynozzletocleanthemost
stubborn dirt.
Danger:
Aim the jet from a certain distance to avoid damage caused by
the high pressure.
Do not aim the jet at people, animals or electrical sockets.
STOPPING THE CLEANER
1) Turntheburnero󰀨byrotatingtheON/OFFswitchtothe“I”
position(g.7A).
2) Let the cleaner run with cold water only for at least 30 seconds
to cool down the boiler.
3) Stop the cleaner by turning the selector switch to pos. "0"
(g.7A).
4) Discharge the pressure from the H.P. hose by pressing the
trigger on the gun.
5) Disconnect the water cleaner from the mains electricity
supply via the Solenoid switch or by unplugging the plug from
the socket.
6)Turno󰀨thewatersupplytap(g.5A).
Warning
-Ifthewatercleanerisleft,eventemporarily,turnito󰀨byusing
the Solenoid switch or by unplugging the plug from the socket.
- Water cleaners with the "Total Stop” device should be con-
sideredaso󰀨whentheSolenoidswitchisinthe“O”position
FIG.10
Washing at high pressure
with a concentrated jet of
water
Turn the nozzle in an anti-
clockwise direction.
Washing at high pressure
with a fan-shaped jet of
water
Turn the nozzle in a clockwise
direction.
ROTARY HEAD (optional
accessory)
The high pressure washer
FIG. 7
FIG. 8
USING
THE CLEANER
CONTROL PANEL
A-On/o󰀨switch
B - Detergent control tap (if
available).
STARTING THE CLEANER
1)Turnonthewatersupplytap(g.5A).
2) Connect the water cleaner to the mains electricity supply by
plugging the plug into the socket.
3) Start the cleaner by turning the selector switch to pos. I
(g.7A).
Warning
The high pressure water jet generates a reaction force in the
lance.Keeparmgriponthelancehandle.
4) Press the trigger on the gun and begin washing.
5) To operate the water cleaner with hot water, turn the ON/OFF
switchtotheHotWaterposition.(g.7A).
Warning
In water cleaners with the “Total Stop” system, the motor starts
and stops when the lever on the lance handle is actioned or
released.
Danger
Do not block the handle lever in the delivery position.
IMPORTANT!
To eliminate any impurities or air bubbles from the water
circuit we advise starting the cleaner for the rst time
without the lance and letting the water run out for a few
seconds.
Impurities could block the nozzle and cause malfunction
(Fig. 8).
USING THE ACCESSORIES.
USING THE MULTIREG
ADJUSTABLE NOZZLE (g.
9)
Pressure must be selected
with the gun switched o󰀨.
Low pressure washing and
detergent suction.
(Version with detergent
suction).
Shift the nozzle forward.
!
!
!
!
!
FIG. 9