iPhotonix 7271G - User Manual

To Next Page

band are restricted to indoor usage only.

the channels 12 & 13. Operations in the 5.15-5.25GHz

Page 6

2600 N. Central Expressway

Suite 950

Richardson, Tx 75080 USA

214-575-9300

Page 1

Page 7

FCC

-1

This device complies with part 15 of the FCC

Rules. Operation is subject to the following two

conditions: (1) This device may not cause harm-

ful interference, and (2) this device must accept

any interference received, including interference

that may cause undesired operation.

This equipment has been tested and found to

comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules.

These limits are designed to provide reasonable

protection against harmful interference in a resi-

dential installation. This equipment generates,

uses and can radiate radio frequency energy, and

if not installed and used in accordance with the

instructions, may cause harmful interference to

radio communications. However, there is no

guarantee that interference will not occur in a

.noitallatsni ralucitrap

If this equipment does cause harmful interference

to radio or television reception, which can be

determined by turning the equipment OFF and

ON, the user is encouraged to try to correct the

interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna

• Increase the separation between the equip-

ment and receiver

• Connect the equipment to an outlet on a cir-

cuit different from that to which the receiver

is connected

• Consult the dealer or an experienced radio/

TV technician for help

The manufacturer is not responsible for any radio

or TV interference caused by unauthorized modi-

fications to this equipment. Such modifications

could void the user’s authority to operate the

equipment.

FCC RF Safety Caution Statement

To satisfy FCC RF exposure requirement for

mobile and base station transmission devices, a

separation distance of 20cm or more should be

maintained between the antenna of this device

and persons during operation. To ensure compli-

ance, operation at closer than this distance is not

recommended. The antenna(s) used for this trans-

mitter must not be co-located or operating in con-

junction with any other antenna or transmitter.

GPON SFU ONT

Quick Install Guide

FCC

-2

This device is intended to be attached to a receiver

that is not used to receive over-the-air broadcast sig-

nals. Connection of this device in any other fashion

may cause harmful interference to radio communica-

tions and is in violation of the FCC Rules, part 15.

The 72xxG North America edition is limited to

channels 1-11. This limited operation can be only set

by software and was set before the product left

the production line. All the products for the North

American market were programmed with this limit

before shipping. Customers have no way to choose

OVERVIEW

The 72xx SFU residential ONT delivers high

quality VoIP voice service, Ethernet data service

for high-speed internet access and IPTV broad-

cast video plus video on demand services. They

provide the following user features: (see Model

List for exact features)

– 2 POTS ports - voice telephone service

– 2 LAN ports - Ethernet

onn

– WiFi

ports

- WiFi

onn

– CATV

ports

–

USB ports

data backups

–

UPS ports

UPS

INSTALLATION

The 72xx SFU ONT can be mounted vertically or

horizontally on any flat surface.

Unpack

Unpack the unit and verify that it is free from

shipping damage.:

Desk Mount

1.) Set the unit on a flat surface considering the

following:

– within reach of the power source

– no thermal obstructions

– not in direct sunlight

– user ability to monitor/operate the unit

Wall Mount

1.) Use wall anchors or wood screws (if mounting

to plywood mounted on a wall), spaced 5.709”

apart center to center for horizontal mounting or

3.543” apart center to center for vertical mount-

ing.

CATV, Return and MOCA services

Model List

Model Functions

Select

2POTS+2GE+MOCA+CATV+Return+WiFi7279G

2POTS+2GE+MOCA+CATV+WiFi7278G

2POTS+2GE+MOCA+WiFi7272G

2POTS+2GE+MOCA7271G

Any Changes or modifications not expressly approved

by the party responsible for compliance could void the

user's authority to operate the equipment.

Need help?

Do you have a question about the iPhotonix 7271G and is the answer not in the manual?

Summary

FCC Compliance Information

FCC RF Safety Statement

Statement regarding FCC RF exposure requirements for mobile and base station transmission devices.

FCC Notice - 1

Details FCC compliance rules, interference, and user obligations for device operation.

FCC Notice - 2

Outlines specific FCC rules for receivers, channel limitations, and operational restrictions.

Product Overview and Installation

Overview

Describes the 72xx SFU ONT residential device and its provided user features.

Installation Methods

Guidance on mounting the 72xx SFU ONT either on a desk or a wall.

Connection and Interface Details

Fiber Connection

Instructions for connecting the fiber optic cable to the unit.

UPS Power and Alarms

Details the UPS power input connector and its alarm pin assignments.

MoCA Connection

Instructions for connecting the coaxial cable to the MoCA port.

WiFi and USB Connections

Guidance on connecting to the WiFi network and USB storage devices.

LAN Connections

Instructions for connecting computers or routers to the Ethernet ports.

DC Power Input

Instructions for connecting the DC power adapter to the unit.

CATV Connection

Instructions for connecting the television to the Coax Network port.

LED Indicators and Environmental Requirements

LED Descriptions

Defines the visual LED indicators for operational status of the unit.

Environmental Requirements

Specifies the voltage, current, operating, and storage conditions for the device.