12
4
As an option, a thermometer or thermostat with 2 adjustable temperatures can be
installed.
The choice of temperature via the switch buttons can then be replaced by the input
of T1/T2
- T2 = Highest adjustable temperature (Main wash)
- T1 = Lowest adjustable temperature (Pre-wash)
Choose temperature
Button 6: START.
Press this button and release immediately to start a program.
Button 7: STARCH.
To starch at the end of a wash cycle proceed as follows:
- In case you dont want to starch some of the linen, remove these first.
- Dissolve the starch in some water.
- Press button 7.
- Press button 6 and release it.
- Add the dissolved starch (in compartment D) when water flows into the soap
dispenser.
- Program sequence: Water inlet - Starch:2' - Drain:30" - Spin:130 - Tum-
ble:30".
- After ending the starch program, press out button 7.
Button 8: HIGH WATER LEVEL (reduced wash action)
If you want to wash in a certain program with high water level and reduced
wash action, press button 8. After ending the program, press out button 8.
Button 9: NO SPIN
If you want to run a program without spinning, press the button 9 before you
press the start button. After ending that program press out this button 9. You
can also choose 8 & 9 at the same time to wash with reduced wash action, high
water level and without spinning.
Button 10: RAPID ADVANCE.
With this button you can at any time skip a part or the rest of the program.
Function buttons (6-10)
p
p
p
p
p
Remarks
Press the start button (6). When the machine is started, the red control lamp on
the fascia panel (A) will light up.
Start the machine
When the red pilot light on the fascia panel turns off, the wash cycle has come to
an end and you can open the door.
End of the cycle
When the middle orange pilot light (B) lights up, the liquid bleach may be added
manually (Compartment D).
When the bottom orange pilot light (C) lights up, the linen softener is automatically
added or the starch may be added manually (Compartment D).
Orange pilot lights
To Next Page
Loading...
