iRespond Lite User Manual

1
Installation and Setup
Installation and Set Up Procedure
Installation and setup is quick and easy. Follow the procedures as described and illustrated on the following
pages.
Setup Procedure
 Unpack the iRespond Lite System
 Install the iRespond Software
 Perform Session Setup
Battery Installation
• iRespond Lite remote units arrive with two AA Energizer batteries already installed. Under normal
use, a remote will run for approximately 130 hours before battery replacement is required.
• To replace the batteries, remove casing on back of unit by sliding downwards. Replace batteries.
Attach casing back to remote by sliding upwards.
iRespond System Setup
Follow the instructions below for setting up the Base and Remote Units.
iRespond Base Unit iRespond Lite Remote Units

iRespond Lite Specifications

General

Brand	iRespond
Model	Lite
Category	Other
Language	English

Summary

Installation and Setup

Battery Installation

Details on the installation and expected battery life of iRespond Lite remote units.

iRespond System Setup

Instructions for setting up the iRespond Base and Remote Units.

Linksys USB Hub Setup

Steps for connecting and configuring a Linksys USB Hub.

Base Unit Setup

Procedure for connecting and powering up the iRespond Base Unit.

Remote Unit Setup

Steps to power on iRespond Lite remote units and note their UID numbers.

FCC Compliance

Software Installation and Setup

System Requirements

Lists the minimum Windows-based system specifications for iRespond software.

Installation and Set Up Procedure

Guide to installing the iRespond software from the CD.

Log In and Account Administration

Change Administrator Password

Procedure for changing the default administrator password.

Account Administration

Account Administrator Dialog

Managing user accounts including adding, editing, and deleting.

Create New Instructor User Account

Steps to create a new instructor user account with username and profile path.

Set Up Classes

Procedure to Create a New Class

Steps to create a new class, selecting login type (PIN or Username/Password).

Setting up a Class Roster

Process for adding student users to a class roster by PIN.

Editing a Class Roster

Instructions for editing or deleting existing student entries in a class roster.

Set Up Test Banks

Procedure to Create a New Test Bank

Steps to create a new test bank and rename it.

Enter / Edit a Test Bank

Guide for adding questions, responses, and objectives to test banks.

Set Up Remote Devices

Set up Remote Devices using the Find Remotes utility

Using the Find Remotes utility to automatically set up devices.

Set up Remote Devices Manually

Manually adding remote IDs to the system.

Editing and Deleting Remote Devices

Procedure for editing or deleting existing remote device IDs.