14
Reset IP Address and Login Credentials • Unit Power is ON
• Press and Hold the Factory Default Button for more than
3 seconds.
• Unit will beep when the default process has started.
• The iCAM IP Address will be reset to 192.168.5.100,
The Username to iCAM7000, and the password to iris7000.
Reset all settings and reload software • Power Unit OFF
• Press and Hold the Factory Default Button (FDB)
• While still holding the FDB, Turn ON the unit power
• Keep the FDB held in for at least 10 seconds.
• Stop holding the FDB
• Do not turn off the power to the unit or remove the network
connection for at least 10 minutes (the unit will reboot several
times on its own during the software reload process).
• When complete the iCAM will have reloaded the software and
reset IP Addresses and log-in creditenials to the defaults.
Restoring The Unit to Factory Default
The Factory Default Button can be used to restore the settings
of the iCAM 7 Series to factory default. This button is located
inside of the unit next to the power switch (see image), and
can be used in two different ways:
Factory Default Button
Factory Default Button Function Procedure
To Next Page
Loading...