3
icon will disappear from the screen. This
indicates that the control buttons have been
unlocked. See Figure 3.
Step 9: Touch the Grid Enabled button (top right).
The Grid Enabled button must be lit before
continuing with the set up.
°F/°C
F
GRID
ENABLED
VACATION
STANDARD
ENERGY
SMART
LOCK
ELEMENT
ALERT
GRID
Figure 3.
Water Heater User Interface
(located on the front of your Energy Smart
®
electric water heater).
Grid Enabled Button
Lock Button
Grid Icon
NOTE: The appearance of the
screen and icons may vary.
4
Complete Setup.
Step 1: Check the Status LED on the controller.
The Status LED should brighten gradually, then
dim suddenly. If it does not brighten gradually
and dim suddenly, press the reset button 8
times with a paper clip (about once per second)
until you hear a beep. See Figure 1. The beep
indicates that the controller has been reset.
Step 2: Open a wireless network control panel on your
device (computer, smart phone or tablet).
A list of available wireless networks should be
displayed (Figure 4).
Step 3: Disconnect your device (computer, smart
phone or tablet) from your home’s WiFi
network.
You will connect to a different network during the
next step.
Example: List of SSIDs Displayed in
Available Wireless Networks
Figure 4.
Step 4: Select the “energySmart” network (Figure 5).
Your device (computer, smart phone or tablet)
will connect to it.
Select “energySmart” Network
Figure 5.
Step 5: Once your computer is connected to the
energySmart network,
A. Open a browser window.
B. Type 192.168.10.1 into the browser’s Ad-
dress or Location bar, then press [Enter].
See Figure 6.
NOTE: The page may load automatically when
the browser window is opened.
Browser’s Address/Location Bar
Figure 6.
Step 6: Follow these steps to connect the controller
to your network:
A. Locate your home’s wireless network in the
list (Figure 7).
To Next Page
Loading...