4
B. IMPORTANT: If your router is set to hide
its SSID, look for its MAC address instead.
You will be asked to enter its SSID during
the next step.
C. Click the “Join” button next to your home’s
wireless network (Figure 7).
D. If necessary, type your wireless network
password in the dialog box, then click OK.
E. When you have connected successfully, the
Status LED will be on steady (no blinking,
fl ashing, or dimming). However, if you don’t
get a steady LED status light, repeat all
steps in this section.
Step 7: Reconnect your device (computer, smart
phone or tablet) to your home’s wireless
network.
Step 8: Register and sign in as described in the next
step.
5
Get started with Iris
®
.
Before you try to sign in, check the following:
• The Energy Smart
®
Electric Water Heater Controller
must be connected to your home’s wireless network.
• Your home’s wireless network must be connected to
the Internet.
• The controller must be enabled before you can
control and monitor your water heater through Iris
®
.
See “
3
Install the Controller,” Steps 6 through 9.
For more information about your water heater’s user
interface, see your water heater’s use and care guide.
To get started with Iris
®
, follow these steps:
Step 1: Register, then sign in to your Iris
®
account at:
www.lowes.com/iris
Step 2: Click the ‘Add Devices’ button.
Step 3: Follow the on-screen instructions.
Customer Care
If you need assistance, call 855-469-IRIS. Help is also
available at www.lowes.com/iris/support.
{MAC Address}
{MAC Address}
Your Wireless Network
Figure 7.
OTHER
To Next Page
Loading...