Roomba
®
s Series Owner’s Guide 9
EN
Note: Do not
spray cleaning
solution directly
onto sensors
or into sensor
openings.
Cleaning the IR Window
and Charging Contacts
Inspect the sensors
and charging contacts
to make sure they
are clear of debris.
Wipe with a clean,
dry cloth.
Removing Debris
from Blower Cover
Inspect blower cover
for any lint or debris
built-up, and wipe
with a clean dry cloth
to remove.
Note: To achieve optimal performance
with your robot and dirt disposal, clean
and/or replace your robot's filter as
needed.
Install a new bag, sliding the
plastic card into the guide rails.
Discard the used bag.
Press down on the lid making
sure it is completely closed.
4
3
5
Note: This will
seal the bag so
dust and debris
cannot escape.
Replacing the Bag
Pull up on the plastic card to remove
the bag from the canister.
Lift up on the canister lid to open.
1
2
To Next Page
Loading...
Need help?
General
