For more information, visit global.irobot.com10
EN
Vacuuming & mopping
Your robot is able to both vacuum and mop at the
same time when the mopping pad plate and mopping
pad are installed.
Before starting a vacuum and mop job, prepare the
room by rolling up/removing any carpets in the area
you want to mop.
NOTE: When the robot is operating with
the mopping attachment, spot clean will
not be available.
IMPORTANT: Do not add liquids such as
hot water, detergent or disinfectant as
they could damage the robot.
After completing your mopping and
vacuum cleaning job, make sure that you
empty the water tank and replace the
mopping pad.
1
Press the Bin Release Button to remove the bin.
2
Remove the pad plate from the bin.
3
Lightly dampen a mopping pad and attach it to
the pad plate.
4
Reinstall the pad plate on the bin.
5
Fill the tank with water.
6
Place the bin back in the robot.
7
Place on the oor and press the CLEAN button on
the robot.
To Next Page
Loading...
Need help?
General
