6 For more information, visit global.irobot.com
EN
Cleaning the Filter Cleaning the Charging
Contacts
Cleaning the Full Bin Sensors
1
1
1
2
2
3
3
4
Remove the bin. Remove the
filter by grasping both ends
and pulling out.
Wipe the charging contacts
with a clean, dry cloth.
Remove and empty the bin.
Remove debris by tapping
the filter against your trash
container.
Wipe the inner sensors
with a clean, dry cloth
Reinsert filter with ridged grips
facing out. Place bin back in
the robot.
Wipe the bin door with a clean, dry cloth.
Clear any debris from the
vacuum path.
Important: The robot will not
run if the filter is not installed
correctly. Replace the filter
every two months.
Closed Door
Opened Door
To Next Page
Loading...
