iRobot Roomba Combo j7 - Additional Cleaning Procedures; Filter and Bin Washing; Edge-Sweeping Brush Cleaning; Sensor, Camera, and Contact Cleaning

8 For more information, visit global.irobot.com
EN
Cleaning the Filter Cleaning the Edge-Sweeping
Brush
Cleaning the Sensors, Camera
Window and Charging Contacts
1
1
2
1
2
3
Release the bin, remove the filter, and
open the bin door.
Use a coin or small screwdriver to remove
the screw holding the Edge-Sweeping
Brush in place.
Pull to remove the Edge-Sweeping Brush.
Remove any hair or debris, then reinstall
the brush.
Wipe sensors, camera window and pad
shelf with a clean, dry cloth.
Rinse the dust bin and water tank using
warm water.
Make sure bin is completely dry. Reinsert
filter and place bin back in the robot.
Note: You can clean your mopping pads
two ways: either by hand washing, or in a
washing machine.
Note: Bin is not dishwasher safe.
Important: Do not spray cleaning solution or
water onto the sensors or sensor openings.
Important: Do not wash the filter.
Remove the filter before washing the bin.