iRobot Roomba Combo j7+ - Robot Maintenance: Sensors, Camera, and Bag Replacement; Cleaning Sensors, Camera Window, and Charging Contacts; Replacing the Bag in the Dirt Disposal

Roomba Combo® j7+ Owner’s Guide 10
EN
Cleaning the Sensors, Camera
Window and Charging Contacts
Wipe Sensors, Camera Window and
Pad Shelf with a clean, dry cloth.
Important: Do not spray cleaning
solution or water onto the Sensors
orSensor openings.
1
Note: Inspect the Camera Window.
If you notice any cracks, please
contact Customer Care.
Note: To achieve optimal performance
with your robot and Automatic Dirt
Disposal, clean and/or replace your
robot’s Filter as needed.
Install a new bag, sliding the plastic card
into the guide rails.
Discard the used bag.
Press the lid down, making sure that it is
completely closed.
4
3
5
Note: This will seal the bag so dust and
debris cannot escape.
Replacing the Bag
Pull the plastic card up to remove the
bag from the canister.
Lift the canister lid up to open.
1
2