Regulatory Information
FCC Supplier's Declaration
of
Conformity
iRobot Corporation Roomba Model:
RVE-Yl
Contains FCC
ID:
UFE-AXGYl
and
contains IC: 6652A-AXGYl
This
device complies with
part
15
of
the FCC
Rules
and
ICES-003.
Operation
is
subject
to
the
following
two
conditions:
(1)
This
device
may
not
cause harmful interference, and
(2)
This
device must
accept
any interference received, including
interference
that
may cause undesired operation.
This
device complies with Industry
Canada
license-exempt
RSS
standard{s). Operation
is
subject
to
the following
two
conditions:
(1)
This
device may
not
cause interference,
and
(2)
This
device must
accept
any interference, including interference
that
may cause undesired operation
of
the
device.
• Changes
or
modifications
not
expressly approved by iRobot
Corporation could void the user's authority to operate the equipment.
•
This
equipment has been tested
and
found
to
comply
with the limits
for
a Class B
digital
device, pursuant
to
part
15
of
the
FCC
Rules
as well as ICES-003
Rules.
These limits
are
designed
to
provide
reasonable protection
against
harmful interference in a residential
installation.
This
equipment generates, uses
and
can
radiate
radio
frequency energy and,
if
not
installed
and
used
in
accordance
with
the
instructions,
may
cause harmful interference
to
radio
communications. However, there
is
no
guarantee
that
interference
to
radio
communication will
not
occur
in a
particular
installation. If
this equipment does cause harmful interference
to
radio
or
television
reception, which
can
be
determined by turning the equipment
off
and
on, the user
is
encouraged
to
try
to
correct
the
interference by
one
or
more
of
the following measures:
• Reorient
or
relocate
the
receiving antenna.
• Increase the separation between the equipment and receiver.
•
Connect
the
equipment
into
an
outlet
on
a circuit different from
that
to
which the receiver
is
connected.
• Consult the
dealer
or
an
experienced radio/TV technician
for help.
• Under Industry
Canada
regulations, this
radio
transmitter may
only
operate
using
an
antenna
of
a type
and
maximum (or lesser)
gain
approved for
the
transmitter by Industry
Canada.
To
reduce
potential
radio
interference
to
other users,
the
antenna type
and
its
gain
should
be
so chosen
that
the equivalent isotropically
radiated power (e.i.r.p.)
is
not
more
than
the
necessary for successful
communication.
• FCC Radiation Exposure Statement:
This
product
complies with
FCC §2.l09l{b) for
mobile
device
RF
exposure limits, set forth for
an
uncontrolled environment
and
is
safe for the intended
operation
as
described in this manual.
Per
FCC requirements, maintain a distance
of
more
than
8 inches (20 cm) between any person
and
the
host
device {Roomba robot).
•
ISED
Radiation Exposure Statement:
This
product
complies with
the
Canadian
Standard
RSS-102
for mobile device
RF
exposure limits,
set forth for
an
uncontrolled environment
and
is
safe for
the
intended
operation as described in this manual.
Per
ISED
requirements,
maintain a distance
of
more
than
8 inches (20 cm) between any
person
and
the robot.
iRobot Corporation, 8 Crosby Drive, Bedford,
MA
01730
USA.
http://global.irobot.com
For
battery
recycling
go
to
call2recycle.org;
or
call l
-800-822-8837
To Next Page
Loading...
