Iron-A-Way A-46 - User Manual

Models
A-46
A-42
E-342
NE-342
NE-242
Surface Mounting Instructions
Tools Needed
Stud Finder (Optional)
Carpenter's Level
Tape Measure
Utility Knife
Phillips Screwdriver
Small Flat Head Screwdriver
1/4" Nut Driver (Optional)
Drill (Electric Recommended)
1/8" Drill Bit
1/4" Drill Bit (Surface Mount)
Safety Glasses
Electrical Instructions
Installation Instructions

Summary

Surface Mounting Instructions

Determine Ironing Board Height

Use the provided chart to set the desired ironing board height for installation.

Locate Mounting Position and Utilities

Find wall studs and identify existing wiring or utilities to avoid during installation.

Prepare for Wall Attachment

Pre-drill pilot holes into the wall stud and cabinet braces for secure mounting.

Mount and Level Cabinet

Attach the cabinet to the wall using screws, ensuring it is plumb and level.

Finishing Touches for Swivel Models

Adjust side brackets and add decorative trim for a polished installation.

Electrical Instructions

Electrical Wiring Preparation

Open wireway, identify supply wires, and prepare for electrical connection.

Connect Power Supply

Feed supply wire, secure cabinet, and connect all power and ground wires per code.

Finalize Electrical Connections and Testing

Secure wire nuts, close wireway, and test electrical components.

Iron-A-Way A-46 Specifications

General

Model Number	A-46
Power Source	Electric
Storage	Built-in storage for iron and accessories
Cabinet Material	Wood
Iron	Included
Color	White
Type	Ironing Center
Electrical	120V
Swivel	180 degree
Material	Wood and metal components
Features	swivel