Need help?Do you have a question about the Iron-A-Way NE-42 and is the answer not in the manual?
Identifies the cross braces within the unit for reference during installation.
Determines the correct mounting height above the floor based on desired ironing board height.
Locates wall studs and identifies utilities to ensure safe and proper mounting.
Confirms sufficient clearance around the unit for the door and user space during ironing.
Creates the precise opening in the wall for the unit according to specified dimensions.
Installs a support cleat for drywall and cabinet stability during recessed installation.
Pre-drills pilot holes in the cabinet and studs for screw attachment during recessed mounting.
Carefully places the unit into the prepared wall opening, ensuring plumb and level placement.
Secures the cabinet to the wall studs using screws in the top pre-drilled holes.
Completes the recessed installation by inserting screws into the bottom pre-drilled holes.
Confirms the unit is fully installed and suggests adding trim for aesthetic finish.
Determines screw locations on cabinet braces for surface mounting to wall studs.
Pre-drills holes in cabinet braces and wall studs for secure surface mounting.
Locates and marks the wall stud for cabinet attachment in surface mount installation.
Partially inserts a screw into the upper cross brace of the cabinet for initial positioning.
Attaches the cabinet to the wall stud by fully inserting the screw into the upper cross brace.
Inserts the second screw into the bottom brace to secure the cabinet, ensuring it remains square and level.
Applies decorative trim or molding to create a flush finish with the cabinet face frame.
Confirms the surface mount installation is fully completed.
General| Brand | Iron-A-Way |
|---|---|
| Model | NE-42 |
| Category | Iron |
| Language | English |
To Next Page